CB44-0614
APPLICATION
The CB44-0614 Cable Seal for Through-Wall Cutouts is designed for new installations and is installed before cables are run. Typically used for sealing room-to-room cable cutouts in the portion of the wall below the raised computer room floor, the CB44 provides a seal that prevents conditioned air from escaping into mechanical rooms or up the insides of walls. The CB44 seal provides a 6 x 14 in./152 x 356 mm cable access cutout for passage of large bundles of power and communication cabling. The CB44 prohibits damage to the wall material or cables and allows for additional cabling in the future.
For smaller cutouts, consider CoolBalance CB55 through-wall cable seals.
Construction: One-piece sturdy aluminum frame, rubber cable rest, nylon 6 brush with EPDM layer Hole Sizes: 6 x 14 in./ 152 x 356 mm
CB44 [for new facilities]
INSTALLATION
CB44 Cable Seal for Through-Wall Cutouts mounts in a 6 x 14 in./152 x 356 mm cutout between two studs on standard 16-inch centers. The unit is installed on the air conditioned side of the wall and can be mounted with screws, double-sided tape or any other bonding agent.
CB55
APPLICATION
The CB55 Cable Seal for Through-Wall Cutouts is available for 4.5 or 6.75 in./115 or 172 mm cutouts where a small number of power and communications cables need to be accommodated. For larger cutouts or where larger numbers of cables need to be accommodated, use the CB44 Wall Seal. Typically used for sealing room-to-room cable cutouts in the portion of the wall below the raised computer room floor, the CB55 series provides a seal that prevents conditioned air from escaping into mechanical rooms or up the insides of walls. The CB55 prohibits damage to the wall material or cables and allows for additional cabling in the future.
Construction: ABS plastic holder with PVC pipe, nylon 6 brush
Hole Sizes: CB55EP-04: 4.5 in./115 mm diameter cutouts
Hole Sizes: CB55EP-06: 6.75 in./ 172 mm diameter cutouts
INSTALLATION
CB55 Cable Seals for Through-Wall Cutouts mounts in a 4.5 or 6.75 in./115 or 172 mm diameter wall cutout. The unit simply slides into the cutout and is mounted with screws, double-sided tape or any other bonding agent. The flange and brush assembly are mounted on the air-conditioned side of the wall for maximum effectiveness.
About Sealeze, A Unit of Jason Incorporated
For more than 30 years, engineers, contractors and installers have looked to Sealeze to design and manufacture brush sealing solutions for a wide variety of industrial and air sealing applications. Sealeze manufactures strip brush in the broadest range of sizes, with the largest number of filament types, and provides the widest range of holders to meet the needs of almost any application. Sealeze has been providing brush sealing solutions in data centers, from floor cable seals to technical furniture and cabinets, since the mid 1990s.
